R/C Tech Forums - View Single Post - KO PROPO EX-1 UR
Thread: KO PROPO EX-1 UR
View Single Post
Old 03-02-2008, 05:21 PM
  #30  
pink_sleeve
Tech Champion
iTrader: (220)
 
pink_sleeve's Avatar
 
Join Date: May 2006
Location: Planet Melmac
Posts: 5,842
Trader Rating: 220 (100%+)
Default
Originally Posted by DrewLoftus
So I just picked up my UR today... a couple questions for anyone with a UR or KO experience..

- Can you adjust the spring tension of the steering wheel? On my m11 you would just tighten or loosen a screw in the middle of the wheel but I don't see that on the UR...I'm not a fan of how hard it pulls the wheel back to center.

- Does anyone have a good way to make the trigger smaller without melting it? I have it as small is it will go an its still too big...I was going to get some fuel tubing but i don't think that will be enough..

Thanks!
I took mine out and dremeled the slot longer so it could go smaller. If you do this be careful so you don't ruin your trigger though.
pink_sleeve is offline  
Reply