Originally Posted by k_bojar

all the 'goo is the same...I've used the "shoe goo" (in the red tube) and other "goo" in the green tube...

its all the same...

and I'VE NEVER LOST A SERVO that was mounted with any of the "goo's"

this is from TC to 12th scale to 18th scale off-road and 10th off-road the stuff just sticks that well...

I have a little trick to get it to set better

1) take a thin piece of servo tape and run it down the center of the servo
2) apply the goo to boh side of the tape
3) peel the back off the take and stick it too the chassis...

the tape allows the servo to stick to the chassis and not move around while the goo dries Plus it also gives you an area to pry the servo off when its time to change the servo