its unfortunate that my local carpet track uses wood covered with smooth plastic as barriers. I hit pretty hard, but if I hit with the graphite parts they ALWAYS break no matter what.
Once is switched to aluminum the car doesn't break, or rarely i snap the arm or bend a hinge pin. I am all over the track until I get the right setup.
anyways the issue im having with my rubber tire cyclone is that the rear end hooks around or does a complete 180 around corners.
Currently Im using the carpet/rubber tire setup from hotbodiesonline.com.
If your not familair with it, if ic an recall:
camber: 1.5 neg
No roll center blocks
3 degrees rear toe in
0 degree front pivot block
0 degree front toe
jaco green pre-mounts
Full sauce all around
Caster: 4 degrees
50wt oil front + rear
stock pistons
Gold/silver HPI springs
4.5mm ride height
.5mm droop front and rear
190mm stratus body
Low-medium bite carpet