View Single Post
Old 02-17-2008, 03:15 PM   #1
wikedgmc
Tech Elite
 
wikedgmc's Avatar
R/C Tech Charter Subscriber
 
Join Date: Feb 2004
Location: San Jose, CA
Posts: 3,239
Trader Rating: 75 (100%+)
Send a message via MSN to wikedgmc
Default LRP brushless motor help

I was installing a sintered rotor on one of my 13.5 motors and for whatever reason I cannot get the screws to tighten on the end bell to put the cap back on. I have done this 4 other times but for the life of me cannot figure out what is going on here.

Any ideas?

I would rather figure it out here than send it back to LRP
wikedgmc is offline   Reply With Quote