The torque figures for the brushless will be somewhat generous because I did not change the inertia settings. I don't see the point of guessing the correct figures so these graphs are only directly comparable if the rotors are the same.
If anyone can give me the correct inertia settings for the different brushless rotors I would be very happy
.
A rough extrapolation of the 10.5's torque curve would give around 300Nmm at 0 rpm . This Dyno does not test at low rpm's. But other than that the 19t dyno results is just like what we have found on the track, a very close and lucky match
.
I gave the laptop away to my sisters so I don't have anything save results at the track with. I will try to get single stored results of systems I can compare with when I get back home. At least I think the dyno can store a single test and then upload it when I get home.
You haven't heard the last of me on this thread
