Originally Posted by
Dawn Sanchez
8.8.4.3 Winding:
Modified Brushless Motors: Only three slot (phase) “Y” wound stators are
permitted. No delta wound stators allowed. Only circular (round) pure copper wire
permitted. No turn limit.
Stock Motor: Only three slot “Y” wound stators are permitted. No delta wound or
slot less stators are allowed. Only circular (round) pure copper magnet wire
permitted. The three slotted stator must be wound with 17.5 turns of 2 strands of
20 AWG or 2 strands of 0.80 mm IEC per slot. The inductance for each slot of the
stator shall be 102.00 Micro Henries minimum and 108.00 Micro Henries
maximum, measured with the rotor removed from the motor.
Super Stock Motor: Only three slot “Y” wound stators are permitted. No delta
wound or slot less stators are allowed. Only circular (round) pure copper magnet
wire permitted. The three slotted stator must be wound with 13.5 turns of 2
strands of 21 AWG or 2 strands of 0.71mm IEC and two strands of 23 AWG or 2
strands of 0.56mm IEC per slot. The inductance for each slot of the stator shall be
57.00 Micro Henries minimum and 67.00 Micro Henries maximum, measured with
the rotor removed from the motor