Originally Posted by
Swede#1
Ok, i need some expert advice on my Go .21 5p
I got it last spring, and ran it the whole summer and didnt have any problems, it ran good.
So, now i got new bearings for it, a turbo head button, OS P3 plugs and Sidewinder 20% fuel, i just had it outside on the street to try out my new truggy and i couldent get it to idle down as it should, after each wot run the engine would rev really high for a while, and slowly settle down to a normal idle, temps where pretty low, around 150F, so i tried to lean the hsn and the idle got even higher but temps didnt really go up, the highest temp i got was 175F.
So, what do i do ? what are the " stock " settings on the carb so that i can " start over "
Also, you were running it during the summer, the air mau be alot cleaner now= leaner running, the cooler air will cause the motor to go lean sometimes, the factory settings are=HSN 1 turn in from flush, LSN 1 turn in from flush, also, run 30% the motor is shimed for it, unless you changed it.