R/C Tech Forums - View Single Post - PPD EZ-LiPo --TC5 and beyond LiPo mounting Solution.
Thread: PPD EZ-LiPo --TC5 and beyond LiPo mounting Solution.
View Single Post
Old 02-09-2008, 07:35 AM
  #118  
JimmyMac
Tech Elite
iTrader: (2)
 
JimmyMac's Avatar
 
Join Date: Oct 2001
Location: NC
Posts: 4,447
Trader Rating: 2 (100%+)
Default
Okay, here I'm home from work finally. Now I'm sitting back drinking a Guinness. Took some pics of the ezlipo and my 416. Here they are. I remove about 2mm of material to clear the motor brace and servo mount and antenna mount. The piece just slides in no prob now. The Express/Trinity pack sits on it nicely. The top deck just clears the battery by about .5mm or so. Thank You Verndog!! Also, this piece also fits into my Tamiya Evo IV with no mods at all. Plenty of clearance for lipo packs under the ultra high top deck. This piece would also slide into my 415MRE if you dremel out clearance for the motor brace. However, the rear bulkhead and top deck may cause clearance issues with lipo packs. Those are my findings so far. Enjoy....











JimmyMac is offline  
Reply