R/C Tech Forums - View Single Post - Hot Bodies - Ask Jesse Robbers
View Single Post
Old 02-07-2008, 09:25 PM
  #67  
Jesse Robbers
Tech Addict
 
Jesse Robbers's Avatar
 
Join Date: Aug 2001
Location: Cincinnati, OH
Posts: 600
Default

Yeah loctite the short button head screws that goes through the bearing that is on the opposite side of the slipper as the spring is. Just don't put too much lostite on the screw b/c the loctite can get into the bearing. Also loctite the set screws in the outdrive. I think that's the only screws in the slipper, but I don't remember for sure??? You shouldn't need to loctite the slipper spring nut, if you do just use a little bit as the nut has a good bit of "stick" by itself.
Jesse Robbers is offline