Originally Posted by
TryHard
Actually, having sat down with a selection of C-hubs this evening, looks like I cocked up on my inital assesment
You CAN use the 416 knuckles in the 415 c-hubs, and the axle will be at the same height.... my bad
You do need to add a shim
above the chub to keep the ball joint in the same height. And need to file off a little bit of material from the steering knuckle, as it's a bit of a tight fit.
Pic of the setup below
See, I don't know everything Nath
HiH
Ed
Cheers for the heads up on the ball joint washer Ed I overlooked that.
Will get a set up for you on what I end up with at Maritime Thursday.