OK ! Great back to set ups.
My Cyclone hooks coming out of corners on power,,,, Going in and middle corner is good, Did it with a Diff and now with a spool and a one way. I am now running.
0* front toe pivot block and have used 1* and 1.5* never more then 1.5* in front.
3* rear toe pivot block.
2mm under ball studs in front, 1.5mm back.
1.5mm under pivot blocks front and back.
4 degree caster.
long front and back links, tried short and middle, still hooked coming out.
1.4 sway bar front none in back but tried 1.2 in back and it was worse.
22lbs front 19lbs back springs.
10.5 motor.
Small technical track with 180* and 90* corners.
Rubber tires and carpet.
BMI 3mm chassis, stock upper chassis.
Man if I could get it to stop hooking coming out I would be one happy guy. Any help would be much appreciated.