Here is my Foam tire carpet setup from Cleveland for the new Mission
Front:
Shock tower-1
Upper Hub Ball-2
Steering arm-2
Upper a-arm mount-1
Lower suspension arm-1
Hinge pin mount-2 deg
Oil-80wt
Spring-40lb
Piston-1 hole on stock piston
Spacer-none
Length-67mm
Droop-1mm (5mm on Hudy gauge)
Anti-Roll Bar-Thick Schumacher
Castor-2mm shim in back and the rest forward
Toe in-0 deg
Ride Height-4mm
Camber-1 deg
Lower wishbones-stock, rear position
Driveshafts-steel
Tires-Jaco Plaid
Rear:
Shock tower-2
Upper Hub Ball-2
Upper a-arm mount-1
Lower suspension arm-1
Hinge pin mount-2 deg
Oil-80wt
Spring-35lb
Piston-2 holes on stock piston
Spacer-none
Length-67mm
Droop-1mm (5mm on Hudy gauge)
Anti-Roll Bar-Stock
Anti-squat-none, blocks flat on chassis
Toe in-2 deg
Ride Height-4mm
Camber-1 deg
Lower wishbones-stock, mid position
Driveshafts-steel
Tires-Jaco Purple
This was my first race with the Mission, so I'm sure there will be a few more tweaks to the setup to improve it.
Good luck to all and lay it down proper, Cypress style!!!!