Originally Posted by
spurgear
I will try to look for this tape. If u have a link for it please post. Well i installed the electronics. What size pinion u use? In all this hard hits everyone is getting. Is the chassis damaged? Carbon split? I didnt apply the CA to the chassis as suggested in the manual. Also i only applied thread lock to the screws they suggested. Do u set the steering throw to all the arm permits?
This is just one example of battery strapping tape
http://www.speedtechrc.com/store/ebp...id=386&id=7181 like I said, you should be able to get it from any hobby.model shop, I think Serpent even do there own version.
Pinion size is dependant upon the motor and track size/layout.
I have sealed all the edges of my carbon chassis parts, and rounded off the edges. It's essential that you do this as it will prevent the chassis splitting. i did once pretty much destroy a car in an impact but in all honesty, I have taken some hard hits recently with no damage
Put some threadlock on the adjusting screw of the servo saver as well.
I set the steering to the max the arms permit at 100% on my transmitter and then adjust dual rate from there.