R/C Tech Forums - View Single Post

01-21-2008, 12:05 PM

#2678

nigelnuggets

Tech Elite

Join Date: Jul 2005

Location: Artesia, SoCal.

Posts: 2,187

Trader Rating: 0

Quote:

Originally Posted by sepentNY

Hey guys I found this servos tell me what you think about this servos
I,m planing to use this servo on the steering.
JR radios.
Z9100S Digital Ultra-Speed MG Servo
Specs
Type: Digital Ultra-Speed Metal Gear Servo
Torque: 150 oz/in @ 4.8V, 180 oz/in @ 6V
Speed: .08 sec / 60 degrees @ 4.8V, .06 sec / 60 degrees @ 6V
Dimensions (WxLxH): 0.827"x1.59"x1.569"
Weight: 2.3 oz
Bearing: Dual Wide Spaced Bearing
Motor Type: Coreless
Gears: Metal
Application: Surface vehicles

and for the throttle
DZ9000S Digital Hi-Speed/Torque Surface
Specs
Type: Ultra High Speed
Torque: 112 oz/in @ 4.8V, 128 oz/in @ 6V
Speed: .08 sec/60° @ 4.8V, .06 sec/60° @ 6V
Dimensions (WxLxH): 0.83" x 1.59" x 1.50"
Weight: 2.2 oz
Gears: Metal Gears.

Please tell me

what do do think, and advice also on what type of radio and reciver should I use, I hear some rumors that spectrum has problems with 1/8 please advice

If you're looking to run the JR Servos, my friend here in SoCal who runs the JR product line recommends the Z8800 series of JR Propo Servos. But the ones you listed sound adequate for the job. Just passing along information!

As far as the Spektrum issue goes, someone people have bad luck, or set up the systems wrong and it causes them to have problems. Paolo Morganti uses Spektrum with his KO EX-10 no problem. He even uses that tiny tiny receiver that they have now.

Reply