R/C Tech Forums - View Single Post - Pinch too TIGHT!
Thread: Pinch too TIGHT!
View Single Post
Old 01-20-2008 | 02:26 AM
  #9  
joe_jenkins's Avatar
joe_jenkins
Tech Fanatic
 
Joined: Jun 2007
Posts: 868
From: Acworth, Georgia
Default
Originally Posted by TomB
no i'm not. if this does not fix it, then it's possible that the piston and sleeve is a very bad match, and something went terribly wrong when it was assembled in the factory. might be one of those 1 in 5000 type scenarios.
such as my murnand modified 35 plus 31 that god broke in half at the block
joe_jenkins is offline  
Reply