R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 01-14-2008, 10:02 AM
  #27944  
Applesauce
Tech Regular
iTrader: (15)
 
Applesauce's Avatar
 
Join Date: Jul 2006
Location: Greensboro, NC
Posts: 492
Trader Rating: 15 (100%+)
Default front arm travel
OK hopefully I can explain this right. First should there be room for the spindle to move up and down between the upper and lower arm. If not where do i need to shim it at? (above the spindle, below the spindle, or on the top of the king pin?

Thanks for your help.
Applesauce is offline  
Reply