This is a rendering of the chassis that we are currently designing here at MPP. Its 7075 4mm aluminum chassis for the NTC3. The design on the rendering is not yet done, as you can see its missing all the screw holes, which will be countersunk of course, and its also missing a chamfer on the outside edges of the chassis. The chassis is symmetrical; it’s not wider on one side than the other like the stock one. It should be available in the next few weeks, please PM me or Modellor on this forum for prices, I will say though that compared with other similar chassis currently on the market this one is priced very low.
Thanks,
Steven Muller
MPP