R/C Tech Forums - View Single Post - Ask Steve "The Evicerator" Weiss
View Single Post
Old 01-10-2008, 04:36 AM
  #5780  
wyl03
Tech Elite
iTrader: (44)
 
Join Date: Feb 2002
Posts: 2,213
Trader Rating: 44 (100%+)
Default

thanks Steve. you are spot on. the RX wiring was the wrong way around.

with prompt responses like this .. it's 1 of the primary reasons i got a 3rd novak speedo.

Originally Posted by Steve Weiss
wyl,

Well it sounds like you might have two problems... let me address the first one:

When doing the one touch setup, you have the start right:

Hold down the button, turn the ESC on and when the red LED comes on let go of the button and pull full throttle.

But where you have it wrong is when the green LED comes on... at this poing you go to full brake, not to neutral!

Once the trigger is at full brake the green LED should blink, THEN you return the trigger to neutral!

Now, in regards to the issue where when you turn the ESC on and you see a green and red LED on solid, this means that the ESC is not getting signal... check to make sure your transmitter is on and working properly, and double check your input harness to make sure that it is oriented correctly on both the ESC and in the receiver!
wyl03 is offline