View Single Post
Old 06-17-2003, 10:54 AM   #2012
rc-zombies
Tech Champion
 
rc-zombies's Avatar
 
Join Date: Aug 2001
Location: NorCal. Napa area
Posts: 7,212
Trader Rating: 8 (100%+)
Default Re: GRAPHITE SHAFT...

Quote:
Originally posted by [email protected]
I was shy to use it since i think it was going to break but it didnt but when you buy it the pins are in same position but after running it at the local track on end is 90degrees off from the other so im affraid its going to break. the car was run in stock and mod that day with a one way too.

anyone else have experience with the the shaft?
the aluminum ends might have come loose is so..a drop of CA will hold it in place...
__________________
HB WCE HARA EDITION CYCLONE: LRP Sphere TC, KO 2363 digital servo.
HB HARA EDITION PRO4: Gone to a new home..

SPEEDTECH|FUTABA|KO|ORION|SPEEDWORLD|HARA
rc-zombies is offline   Reply With Quote