View Single Post
Old 01-08-2008, 10:21 AM   #8788
Tech Champion
Join Date: Sep 2002
Location: Chicago Illinois USA
Posts: 9,126
Trader Rating: 16 (100%+)
Send a message via ICQ to Solara Send a message via AIM to Solara

Originally Posted by Cannonball Dan View Post
Higher at the tyre side

I run the standard TA 05 R A? and D blocks with the Aluminium Rear Upright Hop Up. Can I get more toe in than that?
I went thru exactly what you went thru 3 weeks will need only 1 block...the XA block at the front of your rear tranmssion.

I have the same alum rear up right...0 degree, using the existing D block at the rear...only changed the front block from A to XA. That will gives you 3 degree.

Also...take off all the sway bar.....

After 2 weeks of car is quite good, just a little push at couple turns...might need to trim down the rear toe from -3 to -2.5, that will require a C block at the rear instead of D.
Solara is offline   Reply With Quote