R/C Tech Forums - View Single Post - CEN Matrix TR
Thread: CEN Matrix TR
View Single Post
Old 01-02-2008, 08:13 PM
  #1020  
ILDRVR
Tech Regular
 
ILDRVR's Avatar
 
Join Date: Mar 2007
Location: Austin, MN
Posts: 439
Default

Your motor should come with the factory needle settings. Set them back to factory and lean out the high speed needle a little at a time (1/4 turns) first then move to the low(1/8 turns). (just like you did for break in) This should help you. Also make sure you do not have a leak in any of the fuel line. This will make it act like it is lean.

I hope this helps...Remember to temp often
ILDRVR is offline