oops dont forget to put the clear bind button where you wont lose it,but will remember to put it back.

the last picture shows a screwdriver on one of the two screws that hold the trigger assembly to the radio.that screw is the one you want to space out.i used fuel tubing and a longer screw.the fuel tubing allows you to easily adjust the thickness by torqueing it down a little more or less.i ground down the boss on the other side a little bit,but it is a little risky cuz you can easily grind or cut through the thin wires around it.i also dont think that it really helps the final "feel" of the trigger,but it is up to you.
the first picture on this page shows where to grind.
the second is the screw i used ,lenght of fuel tubing,and stock screw.
the third is it reassembled.