Originally Posted by
jammincrtjames
Does anybody have a carpet rubber/carpet set-up they can give me as a starting point for my S400? Also, Whats the best traction compound for rubber on carpet?
500CST shock oil front and rear 80% rebound
2 Hole pistons Front
4 hole Pistons rear
2 degree caster blocks
1mm shim on outer front ball stud ( camber link stock location)
5 mm ride height front and rear
Front one way 34 tooth gear ( overdrive )
1mm shim inside camber link rear and 2mm shim under outer on hub ( rear camber link all the way long.
2 degree tow block rear
1.6 front sway bar
1 mm shim under front lower a arm suspension holder
orange spring front
yellow spring rear
shock next to outer hole on front shock tower
shock next to outer hole on rear tower
front shock position outside on arm
rear shock position middle hole on the arm
2 degree inboard toe in the front
.75 degree toe out on each front wheel
sorex 24 tires premount
rear ball diff loose but no slip
mazda 6 body for extra rear bite or parma alfa to lossen the car up a little
all aluminum screws above chassis
need to add 90 grams if you use the aluminum screws
Front sway bar inside position on arm
not using rear sway bar
go to 4 degree blocks in the front and keep arms flat for more all around steering
Mazda body mounted 33.5mm from center post to windshield
3 mm droop all the way around on the blocks
4 mm of spacers in front of rear arms ( increase wheel base)
Paragon FX traction compound-tire warmers at 150 degree front 160 degree rear
CO27 30/102 4499 brushes
Trinity 4600 Enrich power
Sorry if I missed anything!! Let me know if I did!!