View Single Post
Old 12-21-2007, 05:05 AM
  #2  
Trips
Tech Elite
iTrader: (16)
 
Trips's Avatar
 
Join Date: Aug 2001
Location: 360 Speedway
Posts: 2,251
Trader Rating: 16 (100%+)
Default

Looking at the picture on Integy's website, it looks like the super lathe 3 takes an AR4 bit. THe easy way to tell, is when the armature is in the lathe, and the lathe is sitting in front of you as if you were about to do a cut, is the comm to the left side, or the right? If the comm is to the left side (Twister, some old Trinity lathes), then that lathe takes an AR4. If the comm is on the right side (Cobra, Hudy, Orion), then that lathe takes an AL4.
Trips is offline  
Reply With Quote