R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 11-17-2007 | 07:06 PM
  #462  
Jason Halvorson's Avatar
Jason Halvorson
Tech Elite
iTrader: (22)
 
Joined: Apr 2007
Posts: 3,955
From: Grand Forks ND
Default
Originally Posted by GuyHuey
Hi all,

I have a Go .28 in an 8T. The motor flat rips, only half a gallon through it and running about 215 degrees. But I keep having a problem with the carb coming loose. The pinch screw is thread locked and is not backing off,but after a few laps the carb will rotate, any ideas or help will be greatly appreciated.


Guy
i would remove the carb and silicone it on...this should help with the carb wanting to rotate...
Jason Halvorson is offline  
Reply