View Single Post
Old 11-14-2007, 06:41 PM
  #8  
22Racer
Tech Elite
iTrader: (67)
 
22Racer's Avatar
 
Join Date: Mar 2002
Location: Wanamingo Mn
Posts: 3,143
Trader Rating: 67 (100%+)
Default

I haven't seen any modded motors that looked like they were done on a cnc. I have alway's been curios why the Picco motors transfer ports are angled the wrong way? (I'm assuming cost, because everything is done from one angle)

Maxximo, nice looking sleeve, usually the cut on the side ports are both on the exhaust side.

Rex
22Racer is offline  
Reply With Quote