Originally posted by futureal
For those of you that are rotating the servo 90 degrees, are you mainly drilling a new hole in the chassis to accomodate the mounts, rather than just taping/gluing it in? I prefer to use the mounts whenever possible.
I haven't really measured out a hole on mine yet, just looking to see how others have done it.
Thanks!
Well, I am using just a good old servo tape. I've clean a surface very well and using either Yokomo or Tamiya heat resistant servo tape. I have crushed many times but servo is still intact. I've choose servo tape because I actually want servo to come off after big crush to save my servo gear.
D.