Hey there, I just finished an RDX build, got her used, but tore her down 100%and built per manual. I set the car up as close to the asphalt set ups that are listed (Using my integy set up station). I successfully run a TC3 and TA05on asphalt.
I believe I might be missing something fundamental... Here is my problem the car fishtails badly on counter-clockwise turns,(it will spin in circles if I let it) but turns perfectly on clockwise turns. I really dont think I am missing anything on my set up that would cause this drastic loss of traction, it has to be something simple.
Set up: 27 turn, 34p, 104s, c27s
Front toe in slight
-1.5 camber Front
-1.5 camber rear
4 degree castor blocks front
Two shims for rear toe-in not sure size looks like 3mm in width Maybe 2 degree of rear toe-in.
4 Black springs 60w front 40w rear 5.5mm height.
I have tried different droop settings to no avail, also tried loosening rear diff.
My next thing will be removing shocks and checking for binding from control arms and or swapping rear shocks left to right.
Any input would be appreciated, Thanks AL