Originally Posted by
Slippery Dan
OK. I guess I'm just slow.
I'm trying to figure out how to get 1degree "front pivot" on my car.
The manual is not very helpful though.
It mentions the vairious combinations about different arm lengths and "wide" or "Narrow" pivots but none of them are stated in degrees.
Since there are 3 degree choices on the setup sheet I'd assume that you have to use a combination of the different holes. But wouldn't that affect the spacing of your arms depending on whether you are using the long ones or short??
Can someone please help.
Thanks.
Order the 1 degree outer pivot block p/n LOSA9696.
http://www.teamlosi.com/Products/Def...rodID=LOSA9696
Most of the pivot angles on the R are set with the aluminium pivot blocks.