Originally Posted by
carbon madness
The only issue with using something for a TC, with a truck, is that a truck is wider then a TC, so it would be pointless to try to eyeball it, when you are trying to get it right.
I have a TC. board that I use for my TC. , I then just bought a extra TC. setup station and drilled out the holes to fit the 1/4'' off road axles.
The toe gage was not wide enough, so I cut it and extended it to so it would fit the Truck and Buggy.
It all works great, and like some one said a few post back , it eliminates the slop of the wheels and bearings.
This was all disused in this thread,
http://www.rctech.net/forum/showthread.phpt=174351&highlight=setup+station
a few weeks back, and there were people on there saying they did not see the need for this in off-road .
I thinks it just a way to be a little more accurate , which can't be bad.