View Single Post
Old 09-16-2007, 05:56 AM   #11653
fastharry™
Tech Elite
 
fastharry™'s Avatar
 
Join Date: Sep 2001
Location: Mahwah, NJ.. USA!! ..... Home of http://www.fastharry.com
Posts: 2,846
Trader Rating: 4 (100%+)
Send a message via Skype™ to fastharry™
Default

Quote:
Originally Posted by hooked_on View Post
I just got some plumbers thread tape for the pivot ball nuts, is there any other tips i need to know before i start assembly?

Thanxs
follow the insructions....they will put you in the ballpark for everything...


put regular steel screws in the last 4 holes in the rear of the chassis...., be careful doing the 2 speed trans....its possible to crack the shoe putting in the allen screws, the car goes together well....if something doesn't fit right, like the 2 speed shaft is too far over, or something like that, it's something you did wrong....everything should be fine on the car...
__________________
www.fastharry.com---search "fastharry" on facebook
See Fastharry in Super Nitro racing at the HPI CHALLENGE...
http://www.youtube.com/watch?v=jzo-cBEnE0c
fastharry™ is offline   Reply With Quote