R/C Tech Forums - View Single Post - New Kyosho CRF
Thread: New Kyosho CRF
View Single Post
Old 09-13-2007, 02:27 AM
  #82  
TomB
Tech Champion
iTrader: (10)
 
Join Date: Mar 2006
Location: www.moorebankraceway.com
Posts: 5,120
Trader Rating: 10 (100%+)
Default

Originally Posted by SuPerDraGon
I found that it is not the screw is not strong enough, just that the retaining pin does not have enough allowance to crimp on to the carb.

What you can do is take out the "retaining pin". There is 2 pcs of "retaining pin" right, one with through hole, the other with 2mm thread.
File/Grind away 1mm from the inside on each side. By doing so, you allow the pin to have extra clearance to tighten the carb.

You will not have loose carb anymore...

good tip, if my carby comes loose again, i will give one of the clamp sections a very small file down.

yeah to kyo-show, i agree the needles are way of from factory. mine was so lean it wouldn't start. had to re adjust top and bottom needles, but after that it was fine
TomB is offline