R/C Tech Forums - View Single Post - JL Racing .12
Thread: JL Racing .12
View Single Post
Old 08-21-2007 | 03:06 PM
  #654  
qcrc's Avatar
qcrc
Tech Regular
iTrader: (11)
 
Joined: May 2006
Posts: 432
From: IA Quad Cities
Default
Originally Posted by jeff1
Last day I was trying to install Kyosho 2D on my JL but I've found a problem. the clutch nut is not as firm as was the 3D flywheel.. I mean I can move the piston through flywheel normally but when I was tighten I used the flywheel pin holder tool and Hudy tool.. I tighten and with the hudy tool I was moving the crankshaft too
I tried to place a tierap on exhaust port so its stop the piston and I can tighten but it broke and this can damage the piston
I was wondering if this tool here is for lock the piston in this case
http://rc-mushroom.com/product_info....oducts_id=3771
http://www.rcmart.com/catalog/produc...ducts_id=15649
Check the collet. I've had to sand them down as they are too long. When I tried to tighten the clutch nut the fly wheel was still loose. The nut was only hitting the collet and not the fly wheel. It's just some thing to check out.
qcrc is offline  
Reply