Thread: Yokomo MR4TC-BD
View Single Post
Old 08-20-2007, 04:54 PM
  #7572  
canto54
Tech Adept
 
Join Date: Jun 2005
Location: France
Posts: 205
Default

Originally Posted by John Pape View Post
Chris Graingers setup from Euros.

Front
Drive train Yokomo alloy spool and fixed centre pulley
Roll-bar - none
Caster block 4 plastic
Camber - -2
Toe angle - 0
Susp spacer 1 mm under all 0.5 mount used
Steering arm - -0 inline graphite
Bladder Tamiya black, no O ring
Body - new version
Length - 1.5mm spacer inside, 11.6mm travel outside
Spring - Yokomo pro dot pink
Oil 450
Piston Tamiya #3
Droop - 5.5 to bottom of caster block
Top link inner 1mm under ball
Shock upper 3rd out lower tower
Shock lower middle
Ride height - 5mm
Ackermann 2nd from back

Rear
Roll-bar - none
Camber - -2
Toe angle 3
Susp spacer 0mm under all
Bladder Tamiya black no O ring
Body - new version
Length - 1.5mm spacer inside, 11.6mm travel outside
Spring yokomo pro dot blue
Oil - 400
Piston Tamiya #3
Droop 4.5 measured to hub, or wishbone
Top link inner - 0 washers
Top link outer - , short silver ball + 2mm washer
Shock upper 2nd in
Shock lower - outer hole
Susp arm - graphite
W/B 2-2
Ride height 5.5

There are loads on pictures of his car particularly on John Doucakis website.
how does he mount the yokomo steering knuckle on the HB hub? I try it but yokomo steering knuckle is too tall for the hub. Does he shorten the knuckle?
canto54 is offline  
Reply With Quote