Originally Posted by
BlackedOutREVO
I would think the motor would be well over fried by then wouldnt it? Even the sintered one from the factory I dont think I would do well past 230, if I remember right, the novak site says 160-175 on the motors, I dont think it said sintered or not tho
When they said that though, it was when they were mostly just using bonded rotors, there's no doubt the bonded rotor is the weak link, & when Charlie or Bob told me about the temp tolerance of the sintered, as far as I know they were only referring to the rotor itself, I agree that I'm not sure if the windings in the stator could handle that much(which is why I said I wouldn't ever wanna try pushing the motor THAT hard)....