Did you make that stearing servo holder? if not how could i get my hands on one? and if not what would be a good servo to go with?
Yes I did make the mount. The stock mount as you know only takes a mid size servo which was too weak for me. I really like the airtronics 94359 servo. New its $120 but you can get them on ebay for a lot less. They are super fast and 200oz. Any full size servo is about the same size and should fit, I would suggest a torque rating above 100oz minimum. I used some aluminum sheet to make the mount and the bolted it over the servo using some stock holes in the chassis. I then just used the stock linkage and flipped the ball stud on the bell crank up on top.