R/C Tech Forums - View Single Post - IDM Products?
Thread: IDM Products?
View Single Post
Old 07-25-2007 | 05:58 PM
  #74  
afm's Avatar
afm
Tech Master
 
Joined: Nov 2003
Posts: 1,811
From: lima-peru
Default

Originally Posted by Motorman
WOW
Hope all is well. Wish you a speedy recovery. I took about 9 months off to collect my thoughts and make some personal decisions. But I'm Back
Thank God all is well know. My best theraphy was getting back to driving, since it speeded up the recovery of my coordination and fine sensitivity According to my Doc. it's the fastests and best recovery he's seen in years...so RC is now medically been discovered, jejejejejejeje.

Going to engine matters..I had good results with domed piston, OS TZ head button (less burn room), 8mm bore crank, dished backplate....and now I'm about to experiment with an OS carb (made a reduced teflon insulator to match I.D).

AFM
afm is offline