Originally Posted by JamesArluck

Here's a cool tip I saw Crashby do.

-Ream out the existing holes as much as needed to get the body to line up properly.
-Get some plastic body washers like these: http://www2.towerhobbies.com/cgi-bin...?&I=LX2932&P=7 .
-Put some shoe goo on the body washers and place them on the body post, shoe goo side up.
-Place the body on the posts and get it lined up as good as possible. The shoe goo will be wet and it can move and slide until the body is centered.
-Gently lift the body up off the posts, the washers should come with it and be stuck to the inside of the body.
-Add some more shoe goo to secure the washers, being careful not to move the washers.

When the shoe goo dries the body should be perfectly aligned.

-James