Originally Posted by
muppet racing
Hi Kodak,
Bad luck !
If you have a 20T alu rear side pulley, you can modify that to fit, as the inside middle shaft pulley, you just need to make the shoulder (that the E-clip sits against) a little shorter, so you can get the E-clip on. You can either dremel it or use a large drill bit, its quite easy.
Then just use your G4S middle shaft with a kit 27T outside middle pulley, and you will be up and running ! You might find running a plastic 27T looks after your middle belt too !!
Good Luck.
Thanks to ur great idea, and Patto confirming with me - we have order those parts to suit the ED trans!
i honeslty bleive this par tof the ED trans is the weakest point and using a SHAFT solid and e-clips shall solve the problem for any racer that accidently t-bones a car on a high speed section of there track!
Just for the record the car i hit swevered over towards my side of lane and this resulted! costly one but sure hope to have fixed for more racing in 3 weeks!
cheers All that helpped - thast how a team works well not like some out there
K1458 -- $11.29
G4 Hard Coated Side Pulley 19T
K1459 -- $14.95
G4 Hard Coated 27T Pulley