Originally Posted by
cdelong
0.071mm is 0.028" and 0.050" is 1.27mm???
M7H... you're basically a retard.... but I'll try to straighten you out.....
And you are?....
A NovaRossi engine (such as a 321P, say-because I know them like the back of my hand) has virtually zero head clearance without any shims. Add 0.7mm of shims and walla... you have 0.028" clearance.
If I say exactly the same, and then you don't understand?, who's a retard here then?
I have not tried this with a Ninja, but lets see if we can work through it logically. With 0.55mm of shims you won't even touch 0.050" of solder rolling the engine over. This means a few things possibly:
So you know a Novarossi engine like the back of your hand, but you didn't even looked inside a Ninja, otherwise you would know....
I know enough.....