R/C Tech Forums - View Single Post - Comm Lathes
Thread: Comm Lathes
View Single Post
Old 04-24-2003 | 05:18 PM
  #35  
wrxmy99's Avatar
wrxmy99
Tech Regular
 
Joined: Nov 2001
Posts: 353
From: Sydney, Australia
Default
OK now that Coxy and I have done the lathe/pink milled alloy car stand swap

I should have asked Coxy this but .....are all bits the same?? Not diamond vs carbide but will a bit from any manufacturer fit an eagle lathe or are there different sizes?

Eagle web site lists

#1388 Sweden diamond bit fits Eagle,Trinity,Twister
#1398 Sweden diamond bit fits Zipp,Cobra,Hudy,Kose

So I am guessing that a Hudy bit wont fit an eagle lathe...

Cheers

A
wrxmy99 is offline  
Reply