R/C Tech Forums - View Single Post - Ninja Engine by GRP
Thread: Ninja Engine by GRP
View Single Post
Old 07-05-2007 | 07:29 PM
  #982  
wallyedmonds's Avatar
wallyedmonds
Tech Elite
 
Joined: Jul 2006
Posts: 3,662
From: Brampton ont canada
Default
Originally Posted by MakChai
Hi guys, I need some help here.Own a R01 and I am confused about the head clearance.My question is,should the shim thickness in total to be 0.6mm or shim it so that the clearance at 0.6mm when TDC.

Running 25% Tornado Fuel with Ninja Pipe. Currently running 0.4mm shim thickness and have a head clearance of 0.95mm.I used a solder lead and turn the flywheel over to get the 0.95mm clearance after measuring the squeeze solder lead.Am I doing it right?
i run 20 tornado and i run it stock but if i run 30 i add the shim that came with the motor
on a short track you can get away with the stock shimming with 25 but on a big track you have to add a shim.
wallyedmonds is offline  
Reply