Originally posted by esham
Now my car installed with oneway. Theoriticly what I understand is the oneway will have auto brake by itself and if I apply brake on power the car will intend to spin!
So I let it rolling by itself entering the corner. But what happen is if I full throttle on staright line than off power ( because want to entering corner) instead of rolling the car is tend to oversteer, spin to right clockwise! Seem like the oneway bearing lock by itself make an a break and make the car spin!
One thing - if i full throttle and than release (off power) on straight line at the end the car tend to turn right or spin right! Is it due to my setup! Again! What happen?
did you use a set up system to make sure the car is square!!