R/C Tech Forums - View Single Post - using channel for flaps
Thread: using channel for flaps
View Single Post
Old 06-27-2007 | 08:32 AM
  #2  
BRENDAN LUGO's Avatar
BRENDAN LUGO
Company Representative
 
Joined: Nov 2004
Posts: 441
From: Poway, Ca
Default
Are you trying to set this up in the ACRO mode?

If you are then channel 7 is controlled by the VR2 knob. You can use PMIX 1 or 2 to mix channel 7 to itself and then the channel 7 switch will control this channel along with the VR2 knob.
BRENDAN LUGO is offline  
Reply