R/C Tech Forums - View Single Post - Barracuda from Alex racing
View Single Post
Old 04-16-2003, 06:51 PM
  #1974  
JDM_DOHC_SiR
Tech Champion
iTrader: (31)
 
JDM_DOHC_SiR's Avatar
 
Join Date: Aug 2002
Location: Chula Vista, CA
Posts: 9,087
Trader Rating: 31 (100%+)
Default

Originally posted by itchynads
Don't take too much of the gears or you will weaken them. Just take a 1/4 of a mm off the tip of the gears so the sharp peaks are blunted. Do this for both bevel and diff gears. After doing this, run the car's drivetrain in using an old motor for about 3-4 hours continuosly.
Yes Just take off enough to remove the Flash that is left on the gears...best to start with the 16T bevel gear and then see how it is..if it needs more go to the Diff gear next
-Dave
JDM_DOHC_SiR is offline