R/C Tech Forums - View Single Post - Barracuda from Alex racing
View Single Post
Old 04-16-2003, 06:38 PM
  #1973  
itchynads
Tech Regular
 
Join Date: Jun 2002
Location: Melbourne, Australia
Posts: 449
Default

Originally posted by kansasracer
no, i was too "geeked" to run the thing...

How much sanding is needed on the gears? With fine sandpaper i assume?
Don't take too much of the gears or you will weaken them. Just take a 1/4 of a mm off the tip of the gears so the sharp peaks are blunted. Do this for both bevel and diff gears. After doing this, run the car's drivetrain in using an old motor for about 3-4 hours continuosly.
itchynads is offline