Originally Posted by
Jon Kerr
First make sure that the pivot blocks aren't trying to turn when you tighten the screw. Also, you can take the quick clips and sand them down just a touch to make them fit better without binding. But don't take off too much so you'll create too much slop.
I didn't tighten mine til I had all the blocks attached to the bulkheads. I found it easier to tighten everything up once the blocks where all together and attched to the bulkheads. I would tighten one part of it at a time and check for binding. If non I went to the next part and tightened. No binding this way.
I did have to sand my shims a tad with emory cloth but not a big deal. Everything is nice and smooth with no binding.