Originally Posted by
va_connoisseur
Installation question...Do anyone have any suggestion of an easy method of attaching the steering rod to the servo saver in Step 45 of the manual? I could not find a way to get an allen wrench in there to hold the screw to tighten the bolt. Thanks in advanced
Ahhh I've just checked the manual where you are up to - yep this is really difficult I think I used a allen key to get at but I've found it much easier to leave the servo saver attached to the top deck and remove the steering arms when I take the top deck off - this means you unscrew the servo saver from the bottom of the chassis rather than the top deck. Much easier and you the bearings don't drop out.