Originally Posted by
2-Bad
Just out of interest... where have all your screws broken... Mine all broke just above the diff nut.... Hence, after reading the build guide below, and seeing what Hara's done on his car I thought it’s reasonable to give his method a try. So far it’s turned out well for me....
I'm assuming that the diff nut has trouble sitting perpendicular to the screw and gets kinked over and snaps, but with the washer in place the nut must sit better in the diff housing and its all good from there... IMO
Hara Building Guide
http://translate.google.com/translat...lr%3D%26sa%3DG
Yes this is a good tips for the plastic diff but it's not possible with the aluminium diff, because the blade will touch the nut if you add a washer.