Sydewinder-Thanks. I thank the other cotributors as well. A lot of experience here.
Here is a pic of the Novak 3.5R which I am making ready for the eventual return of my GTB speed control. I though you might want a peek from the backside which you may not have seen. Note the black stack (core) around which heavy gauge wire is wound. This stack increases the inductance (amount of magnetism produced by each bit of current) at the expense of some hand work installing the wire. Also note the small hall effect sensor array. I need a new harness which melted in my last bearing seisure meltdown. I'll borrow one from anther motor. Not too hard to dissasemble. Just unsolder and it all comes apart. I made some marks to be able to restore the same timing.
John
Last edited by John Stranahan; 05-25-2007 at 09:42 AM.